Alabama thread!

Im already different with what ive got. Just thought about kicking it up a notch.

 

do you mean LT or just Radflo..

also that's a lot of coin for used, but if you can get it more power to you.

 

Just radflow. No lt for me. Im not gunna ask that much lmao. I was just messing with @InfernoChalupa

 

i'd be curious on if that upgrade over what you already have is worth it.

 

There the same level as king and ads which is much better than what i have. Plus ill gain more droop front and rear.

Oh and clickers

 

Yes sir, they have put alot of work into that truck and there is alot more to come. The toomanytacos guy is a super nice dude as well. When its all done its gunna be killer. But Mobtown is now a radflow dealer and ive been thinking about jumping on the bandwagon. I almost went radflow before i got the dobinsons they were just more than i could afford at the time.

 

10-4 come get on and get em ill have em off by the time you get here. Im at 0U812 wallaby way greenbo alabama

 

how much will the shutdown 20/59 affect you?

 

Just got the rotors and pads changed on the 4runner. Hoping that solved my wobble issue. Rotors definitely needed changed but not sure they would affect the vehicle unless I was braking..

 

I might have already started on a set that could be yours...

Easier to make them in batches and if you for some reason don't end up with them, I doubt getting rid of them would be hard. It also keeps me from using my material for other stuff I shouldn't be building with it. haha.

 

Won't be done that soon. Lol. I'm planning to put in a couple full days in the shop over the long weekend so you'll see pictures on Monday probably.

 

Friday afternoon meetings can suck it!

 

Very little. I don’t drive through Birmingham much

 

Same it’s going to be a bitch, not looking forward to the closure at all. I thought it was a joke when my buddy told me...

 

People that own them beat on them pretty hard

 

Got me a new badge for my truck

 

I’ll probably also go with the AT3W’s. Probably going with something a little smaller, 275/65-18 I’m thinking.

 

How does everyone on this page have their way of getting machined parts.

30 mpg 1st Gen Tacoma’s that weigh less than they did from factory