Annoying seatbelt alarm!!

Did ya get chime turned off? Didn't see where you had or whether you had white faced gauges or not. If so that link way back doesn't work. That was for black faced gauges.

 

Ok thanks for the help

 

No it didn't work so I just said the heck with it, anything else I can try?

 

Can't remember, but thought I read in one of those chime threads someone did get it turned off without going to dealer and a couple did post up about having dealer turn it off.

 

I'll check thanks

 

1) Turn the Car 'ON', but do not start the engine (Leave your foot off the brake). Cycle your trip reset knob until it reads ODO. Turn the ignition back off. Wait a couple of seconds.
2) Make sure seat belt is not fastened
3) Turn the ignition back on, do not start the car (Leave you foot off the break) As soon as you see everything light up, press and hold the trip reset knob and do a long 12 second count.
4) Keep your finger on the trip reset knob. Fasten your seat belt, as soon as you fasten your seat belt, you should see the ODO display go from XXXX miles to "b-on". At that time take your finger off the trip reset knob and press it again. It should cycle to "b-off". You should be all set and turn the ignition off and unfasten your seat belt.

 

^^^^ that is for black faced gauges. Not same for white face gauges on 2011s that came with them.

 

Oh ok is there a different code to do for the white faced tacomas

 

Just have them shut it off when you do your 5K service.
Might as well do both front seats at the same time.

 

Ok thanks