Another dreaded, lift, tires, wheel post. Will it fit. *stock wheels*

Finally got my Eibach Pro lift in… getting my ducks in a row to install in the few week or so. My list is as follows, Eibach Lift, SPC UCAs, 1” Bora wheel spacers. Planning to have 285/70/17 tires on the stock sport wheels.

My question is this. And yes, I have searched and searched. Literally just read every page of a 29 page on a lift/tires/stock wheels thread.

Are the 1” spacers going to be enough to keep from hitting the UCA? Everything I’m seeing is everyone using the 1.25” Spidertrax. I’m assuming cause that’s one of the only sizes they have. I went with the 1” due to not being crazy about using spacers in the first place and wanting to have “just enough” to make things right and work in harmony. Now that my plan is about to be put into play, I’m overthinking it I think. Any input would be appreciated

 

Don't forget the ECGS Needle Bearing

 

I have that too!

 

My conclusion after doing less reading than you (but still a lot) is that you will likely need to do a CMC to fit 285mm width 33" diameter tires depending on your new equipment, truck, driving style, and tolerance for rubbing. I had too much rubbing for my tolerance with 255mm width 33" diameter tires (rubbed when stuffed while turning), but I solved it with an alignment using my SPC UCAs. No CMC required.

 

Yes, *stock wheels* will fit.