Any woodworkers?

$CDN too unless you got redirected

 

Any one used lemon oil for anything? Found a gallon of it at my friends flip house...

 

Looks like a deal to me. Owner says it was in a fire but might still work with a new power cord.

 

Doesnt look bad, looks like some gunk on the table...

 

I wouldn't hate having just the heavy flat cast table to do something fun with.

 

It would make a cool flower pot or something. Bet the top is pretty pitted in the miter slots though.

 

Sand paper would take care of that, id be worried about the motor being over heated. Id have to look at it in person for sure

 

Better man than me. I don’t really trust steel that’s been through a fire. I’ve been keeping an eye out for a band saw, even though I’ll probably buy new after the winter. Anyways, seen this and thought it was interesting.

 

id worry more of higher heat, if the paint was blistered. Cast iron was warped, etc...doesnt look bad for $50

 

https://spokane.craigslist.org/for/d/spokane-new-wen-6x-48-belt-grinder-9/7027102753.html

 

Typically they are cast iron...going to take a lot of heat to warp that...paint isnt even blistered.

 

Fair warning- did not order but researched as price seems far too good to be true. Just thought I’d post for those that get too excited to research.



50” fence system for under $60.00?!
https://www.whalegot.com/delta-bies..._4u0xDuu_COd80Y3X9m2wSMXKeUWeSYEaAr_yEALw_wcB

https://www.scamfinance.com/whalegot-scam-review/

https://scamzeroed.com/what-is-whalegot-com-scam-exposed/

 

Just picked up one of these on the cheap. Anyone know if it will mount to a Craftsman Pro Router table, there is a guy with one NiB on CL near me for 45 bucks. I did some research but couldn’t find a solid answer.

 

I would imagine that, Craftsman being what it is, only a Craftsman router will fit. You can always make an adapter plate.

 

Just drill and countersink holes if it doesnt

 

Just got back from the lumber store. Man I love the lumber store! Got some 4/4 walnut, and some cherry. Now to make some dust....

 

Honestly, just make one. Do it on a TS wing, big piece of MDF that you can clamp to the edge of your bench, or mount it to a bench tool base. Unless you go all out for an incarta or other gee wiz table, it’s not really worth your cash.

It’s also a great learning opportunity.

edit; Looked up the table and it has a plate (plastic?). If you do decide to get it, you could easily make a new plate or drill new holes in the plate. If you decide to go this route, I doubt we wouldn’t be able to help you fit it to the table IF the holes didn’t line up.

 

Thanks!