Anyone into R/C?

MOTHERFUCKINGSHITPISSFUCKASS

 

I CAN'T SOLDER WORTH A FUCKIN SHIT

 

I think the actual problem may be that the iron isn't getting hot enough. It's only sort of halfway melting the solder...

 

Question, my motor wires are color coded red white and black. My esc wires that connect the the motor are yellow blue and orange... What goes where?

 

I'd assume your motor should be labeled Positive, Negative, and Ground

 

Im not sure it really matters, i do know if the motor runs backwards just switch any of the 2 wires. I know its not much help

 

you should have info for "A" "B" "C" on the motor tabs, then you can look up ESC sequence for which is which in manual or online

 

There isn't anything on the motor. It's sensorless if that makes a difference

 

It don't matter, like Devil said any wires any where, swap any two if motor runs backwards.

 

I only have one direction on my throttle channel? Trying to fix it with re-calibration.

 

No, just swap any two of the wires, don't mess with the radio. Motor wires.

 

I'm trying to run batteries, and keep up with you at the same time.

 

Its like the esc will only tell the motor to go one direction... WHAT the fuck? Also, I just had a brush with the death. I turned it on and it went WOT all of a sudden and flew across the room.

 

So you only have forward and no reverse or vise versa? if thats the case, you need to get the esc out of its race mode. the motor wires only change the direction the motor turns.

 

Zackly.

 

^^Just figured that out. Reverse lockout is one. WHAT THE FUCK?

 

I have to plug it up to a computer to do that... AND I DON'T HAVE THE FAWKING CABLE WITH ME. GOT DAMMIT. FUCK ME RUNNIN. I HATE THIS SHIT.

 

Nitro...

 

what esc did you get? when i got my sidewinder esc, it had reverse lockout on, i was able to get it out by using the controller in a sequence of beeps rather then hook it to a computer. Was a pita but it worked, not sure your esc has that option