1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Anyone istall a URD shortshifter?

Discussion in '2nd Gen. Tacomas (2005-2015)' started by 1tacoplease, Feb 24, 2009.

  1. Feb 24, 2009 at 11:22 PM
    #1
    1tacoplease

    1tacoplease [OP] I like my truck!

    Joined:
    Dec 11, 2008
    Member:
    #11478
    Messages:
    508
    Gender:
    Male
    Temecula
    Vehicle:
    2008 BSP 4x4 6 speed
    265/70/17 BFG RT's, FJ 17" rims with 1.25" spidertraxx Debadged, HID's, URD short shifter, Bilstein 5100's in the front, TSB and 1" block rear, URD TCAI with maf calibrator, JBL long tubes, DT Y pipe, Gibson exhaust, Walbro 255 fuel pump, Pioneer stereo, Bak flip G2 tonneau, TRD skid plate, MB Quarts all around with dynomat, Viper Alarm with motion sensor
    We installed it and followed the steps but I hear this grinding coming from under my feet when I drive. It doesn't feel like the gears because there are no vibrations in the stick. I think it might be the driveshaft? Anyone have any tips or suggestions?
     
  2. Feb 25, 2009 at 4:25 AM
    #2
    Burns

    Burns Well-Known Member

    Joined:
    Jun 19, 2007
    Member:
    #1871
    Messages:
    3,670
    Gender:
    Male
    NJ
    Vehicle:
    Truck is Sold
    I installed one on my old X-Runner and I had zero problems with it. If I was you I would recheck the installation and make sure everything is installed correctly.
     
To Top