1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site
    Quick Links: TRD Pro Grill Garnish Installation X2 Power/Northstar Group 31 AGM Battery install on CBI Tray (3rd gen, picture heavy) Scangauge II Mount 3D Printed ASA! Anyone replaced tensioner pulley on 3rd gen 3.5 liter? Go Pro Mount Basic chemical guys products to buy?

ARB BP51 THREAD -- 3RD GEN

Discussion in '3rd Gen. Tacomas (2016-2023)' started by TheToyotaGarage, Sep 25, 2017.

Page 4 of 4
  1. Nov 7, 2021 at 8:15 AM
    #61
    Jose_Dirte

    #61
    Jose_Dirte Life's a garden, dig it

    Joined:
    Dec 12, 2018
    Member:
    #275687
    Messages:
    660
    Gender:
    Male
    First Name:
    Joey
    Green Acres, CO
    Vehicle:
    A Tacoma, just like everybody else...
    Sorry, I was asking about what your pre-load on your front coil overs is set to.
    ARB has fantastic tech support (although can be difficult to get through to) and will send you a new unit if they believe it has a defect.
    I have found calling them is best vs. emailing to initiate contact.
    Sliders is a bizarre thing to blame if you didn't have the problem before the suspension install.
    Maybe check the top mounts and make sure the bolts are torqued to spec and that the rubber bushings were installed in the proper order.
     
    Jose_Dirte, Nov 7, 2021
    #61
  2. Nov 7, 2021 at 9:49 AM
    #62
    built_not_bought

    #62
    built_not_bought Member

    Joined:
    Nov 4, 2021
    Member:
    #381347
    Messages:
    13
    Gender:
    Male
    First Name:
    Devin
    Vehicle:
    2017 Tacoma TRD PRO, 6MT
    CBI Bed Rack, Pelfreybilt Mid Skid, CBI Sliders, Prinsu Roof Rack, OGE Dual Battery, Blue Sea System Accessory Panel, ARB Air Compressor, Safari Snorkel, OME BP-51 Shocks, Timbren Bump-Stops, OME Dakar Heavy Springs, FN Wheels F(X) Pro Wheels, 285/70 R17 General Grabber X3 Tires, Nitro Gear 4.88 Gears, Front ARB Air Locker, MBRP Cat-Back Exhaust, Red Arc Tow Pro Elite, Magnuson Supercharger
    from factory, they come with 5mm of preload, which arb says gives a stock truck 2” of lift. So unless you told the shop to adjust, I’m guessing they installed as is. If so, topping out probably isn’t the cause.
     
    built_not_bought, Nov 7, 2021
    #62
Page 4 of 4

Products Discussed in

ARB D29XL Old Man Emu Dakar Extra Leaf Spring
$73.34
To Top