1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Attaching base mount behind the screen on dash?

Discussion in '4th Gen. Tacomas (2024+)' started by infantry317, Feb 6, 2025.

  1. Feb 6, 2025 at 5:57 AM
    #1
    infantry317

    infantry317 [OP] Well-Known Member

    Joined:
    Aug 15, 2019
    Member:
    #302280
    Messages:
    149
    Gender:
    Male
    Minnesota
    Vehicle:
    2019 Tacoma TRD OR
    None yet
    So I'd like to 3D print a base for phone mounts/Ram balls, etc. but my question is how is everyone attaching to the dash/screen? I don't feel like tearing my truck apart to figure it.

    Not worried about it being strong enough as I use PETG-CF which is pretty tough stuff. I already did a center "oh-shit bar" phone mount that is holding up well.

    Any help would be appreciated.
     
  2. Feb 6, 2025 at 9:28 AM
    #2
    timetoeatpotatoes

    timetoeatpotatoes Well-Known Member

    Joined:
    Dec 10, 2024
    Member:
    #462122
    Messages:
    57
    Gender:
    Male
    Vehicle:
    2024 Bronze Oxide Trailhunter
    i have ics fab mount that goes there and you remove a piece of trim and use the existing bolts to mount it. thats what I would do if I had made my own.
     
    infantry317[OP] likes this.

Products Discussed in

To Top