1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Aux Fuse Box Panel Needs Advice...

Discussion in '2nd Gen. Tacomas (2005-2015)' started by Denk, Dec 30, 2012.

  1. Dec 30, 2012 at 1:26 PM
    #1
    Denk

    Denk [OP] Alles Gute!

    Joined:
    Oct 11, 2012
    Member:
    #88739
    Messages:
    687
    Gender:
    Male
    PNW
    Vehicle:
    '13 Spruce TRD Sport DCSB
    I've completed cutting/bending the panel and fabbing the main support, however, the back edge is still a bit flimsy. Do you think it would be a good idea to use the lower bolt on the master cylinder?

    Panel - 22ga steel sheet (probably should've gone 16ga on this, oh well...)
    Main Support - 1/8" steel rod

    Here's a wide shot showing the bolt I'd like to use...

    IMG_2910_58c88aba791bab3590928bacb788547c400c8ba3.jpg

    This is the main support, utilizing a bolt in the main fuse box mount...

    IMG_2912_28fbee158779367b033b2b6a655813031ebb7858.jpg

    General shot of the panel. I still need to cut out the red circles for routing wires... or do you think I'd be better off cutting slots or smaller holes to maintain integrity?

    IMG_2911_24c1c66001b044ee1c9805bfec44265ebb882169.jpg

    Thanks for the help. This place is invaluable!
     
To Top