AZ BS Thread 4.2⁰

My fan blower was only working on high on my 2014. Common problem, I've been putting it off because it's so damn hot that I only want the AC on full blast. Last camping trip I drove up at night and it reminded me I need to fix that. I bought the "upgraded" new connector and resistor off Amazon. OEM Toyota parts (allegedly). Now the first and third speed are the same. It comes on low, then the second speed is faster, then the third setting goes back down and fourth is full blast. WTF. Anyone have any ideas? I searched but came up empty.

 

Not surprisingly with the wind I just drove through back north from PV. Then got soaked to get a SpeedWay back up in Flagstaff.
I thought Monday was shit. Todays been Fkd

 

I was all over the east valley today, pretty spotty mostly, but around 1pm Queen Creek got slapped hard with rain and wind for about 15 minutes and then just like that it was blue skies again.

 

Birthday boy is 10 and wore his crown long enough to earn his cookie

 

Im over in Show low. We got the same tornado warning but just got pummeled with rain.

 

Need a camping spot recommendation. Must have pine or pinion trees and no where near anyone else. Any ideas?

 

How much of a drive are you wanting to make? A drive up 89 to Prescott NF would be relatively close (~90mi).

 

Especially since so much of that area is all greened up

 

What day of the week? How far are you willing to drive? Are you ok with cold temps? Lows are in the 30s by the big mountains in Flagstaff now and will be below freezing very soon.

 

dumb question, probably... but forgive me, first time house owner and all that.

There was a big ass weed that had cropped up after the monsoons that I finally got around to yanking. Turns out it had grown up inside the... flashing? (I think that's what it's called)

Anyways, weed go up inside wall & door frame.

I got it back out of there, but do I hammer the flashing down to be super tight against the foundation, or what am I supposed to do there? Won't bugs just crawl up in there if there's a gap? And is there supposed to be basically nothing around an exterior garage door frame?

 

Well it is the green one.

 

If you need any set stuff.. like a k message me, plus i shoot Fuji 4k video also ..

 

Willing to drive a few hours or so. Prescott flag Payson are all fine

 

Like to be a weekend. I don't like the cold but I can handle it. Have the gear to support colder temps. Willing to drive a ways. Flag Prescott Payson and they liked are all fine

 

What are you new to the state or something?

 

Fack.

I have a white one you can use. Your block is iron?

 

A picture would help immensely

 

Yeah it is iron. Might be quite a trek for a 42 dollar disk though. May be more economical for me to order it. It's all good. I really appreciate it.

 

I'll try to remember to grab one when I get home from work

 

I did the same thing... bought the resistor and replaced it the first time, about a year or two later it started doing the same thing. I took it apart again to inspect it and noticed that the plug that goes into the fan showed signs of heat/burns. I went and bought the doorman kit with the upgraded wiring and resistor. Since then the fan has been working like it should..

Next thing to do is to find a fan that puts out more air... These aftermarket fans don't seem to put out the same air as the OEM fan IMO.