FWP Fab Bed Rail Mounts

So i have been selling these mounts for a few months now and i have finally gone out and bought an ax and shovel to mount! I was a bit concerned with the length of the shovel working with my ammo cans, but i have a long bed and it turned out great! I still have access to the storage compartments also! Here are a couple photos i grabbed.

 

Here is a photo i took the other day, it shows both the hi-lift and universal mounts.

 

Would these work for a 60" Hi Lift. It's going to take every inch of the bed. I'm not sure if these will hold it far enough off the side of the bed to make it past the part that stick out near the tailgate.

See picture below:

 

They should. If you hi-lift fits along the rail then you can place the mounts where ever you want. Also there are a couple people that have cut down the length a bit to make them fit.

 

So i just designed one of these....
They can be used to mount CB antennas or light pods. Mount them as the are in the picture for a CB antenna, flip it over for a light pod mount! If you flip them they sit level with the bed rail caps.
More pictures coming of them mounted! Just wanted to post them up to see if there is any interest. $20 for a single mount painted w/hardware, $30 for a pair painted w/hardware shipped to your door!

Let me know what you think!

 

Ok i have a couple photos of the new cb antenna / led pod tabs, mounted up. Let me know if you have any questions or comments!



How i would mount it for a cb antenna....


How i would mount it for LED pods....

 

Just got back from a trip through some Colorado mountain passes. Went up to 13,114 ft and back down and never had any problems from my mounts! Hi-Lift secured, didnt rattle, and made it home! I think they stood the test!

 

Paypal and Email sent.......

 

Sweet! Check your inbox, i sent you a reply.

 

If I send you measurements, can you make them a little shorter for bakflip rails?

 

I sent you a PM

 

@Zac of all trades Here's a pic of a Rotopax DLX mount with the universal mount I got from you.

The holes in the provided mounting plate are right at the edge of your mount so it wouldn't work with the universal mount very well. If you put the DLX Upright base directly to the mount it would work pretty well. But to use the full kit your mount would need to be wider.

I'll bring the stuff this weekend and you can mess around and borrow it if needed.

 

I'd like to buy 2 sets of the rail mounts, painted + hardware. PM sent.

 

I'm interested. What's the size of the hole? Thx

 

Damn it! Ok well i can easily make a bracket that will be wider. What i am also concerned with is how high the top of the tank will be, i would like the tank to rest on the bed floor and then the mount just holds it against the wall. I just need to play with the mount and a tank so that i can get good measurements.

 

Sweet! How many do you need?

The hole that the bolt passes though is 5/8", the hole that the antenna or light pods will mount to is 1/2".

 

Yeah, I need to mount my Tusk whip flag mount to it. I believe its 1/2. Should work?

 

Yeah it should work... i sent you a PM

 

So i found out that my hi-lift mounts work great with the front runner bed bars!

 

For those of you that want to mount these in your bed shell....