Bed width and depth on 2nd and 3rd gen Tacomas for Flip Pac Camper

I'm thinking of selling my beloved Flip Pac, it fits perfect on Gen 1 shortbed. Width is 64", depth is 63". Could anyone post the shortbed dimensions on Gen 2 and 3 tacomas to see if it would fit? Thanks

 

if it fits a 2nd gen shortbed ill buy it..

I can take measurements for you on my taco, are the measurements you just gave the outside dimensions or inside of the flippac?

 

So bed length from the very front outside of the bed closest to the cab, to the end of the tailgate cap at the back is 63.5"
Bed width from the outside of the bedside caps is between 62-63.5" depending on where you stop on the beside cap. 62 being just off center to center of the caps, and 63.5 being pretty much to the end of each beside cap, to the other

Bed length from the inside of the bed mount rail, and stopping at the tailgate cap, is 59.5"
Bed width from the inside of the bed between the mount rails is 57"

 

63" long x 64" wide are the outside dimensions with about 4" wide base on the bottom edges.

 

With the FlipPac I had on my T100, which has a similar tailgate to a 1st gen, the bottom of the rear window overlapped (hung outside) the top of the tailgate and sealed against the top 2” or so of the tailgate. Not sure about 2nd gen, but that certainly wouldn’t work with the thick, curved tailgate of a 3rd gen. But manageable I’m sure, with some trimming and gasketing, to seal against the top surface of the ‘gate.

 

Thanks for the good info.

 

Did you ever end up selling the FlipPac? I'm looking for one for my 2004 Double Cab.