Bilstein 5100's and Stock Coils

I'm about to buy some 5100's for the front in attempt to level out the truck. My question is, will I be able to max out the 5100's ride height and still run stock coils? Also would I need to install an

$190 add-a-leaf kit for 1995-2023 toyota tacoma - 21.5" short AAL set with isolator pads and square bend u-bolts

add-a-leaf kit to the rear if the front shocks are maxed out or would I be able to get away without it?

 

I have no first hand experiece as my 5100s are in the mail right now. I have Dona alot of reading on the subject and bilstein only recommends the use of stock could and the reading I have done says with nothing done to the back.with the bilsteins on thefront at the highest setting most trucks are slightly nose high. And some even say there truck is about a half inch high in the nose on 1,75 setting. But take that with a grain of salt again I have no personal experience with them yet