1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Blank switch help needed.

Discussion in '2nd Gen. Tacomas (2005-2015)' started by BogHootTaco, Jul 13, 2008.

  1. Jul 13, 2008 at 1:34 PM
    #1
    BogHootTaco

    BogHootTaco [OP] Member

    Joined:
    May 26, 2008
    Member:
    #6885
    Messages:
    18
    Maine
    Vehicle:
    08 Double Cab Long Bed
    First off I'll say up front that I'm horrible at anything electrical or mechanical, so I'm sorry if this is stupid question.

    I was taking off the blank switch panel in between my rear airbag button and traction control button on my 08' DC. Located to the left of the steering column.

    Much to my surprise, when I did I found there were already wires going to it.

    Does anyone know what these go to?
     
  2. Jul 13, 2008 at 2:01 PM
    #2
    silver07taco

    silver07taco Well-Known Member

    Joined:
    Apr 27, 2008
    Member:
    #6241
    Messages:
    4,554
    Gender:
    Male
    First Name:
    COIL
    Maryland
    Vehicle:
    13 Tundra RCSB 5.7 4x4,07 Tacoma AC 4.0 4x4
    2013 Tundra RCSB 5.7 4x4, 2007 Tacoma AC 4.0 4x4
    Probably wiring for an accessory your truck didnt come with.
     
  3. Jul 13, 2008 at 2:44 PM
    #3
    Finch Taco

    Finch Taco Member

    Joined:
    Mar 18, 2008
    Member:
    #5373
    Messages:
    17
    Charlotte, NC
    Vehicle:
    09 MGM PreRunner DC LB TRD Sport/JBL
    I believe that blank is for the DAC (Downhill Assist Control)
     
To Top