Brute Force Fab official on TW

Haha I actually had that one on my front bumper before I realized there were holes in the panel below to mount the plate to.

But yeah, most seem to be that design so i'm worried they'd be too bulky to flip up with clearance.

 

YRC picked it up on the 7/9 and delivered it 8/4 pretty shitty if you ask me. Changed delivery dates 5-6 times. Then back dated my delivery date to 7/16.

 

But Billy’s lead times we’re short tho right?

I think it was less than a month when I reached out to him via text, until the bumper finally came here to Texas.

Got it on last week and really regret not getting the swing out.

I think my rear end is too bulky compared to my CBI front now… Thinking about switching to a C4 overland full bar front

 

Billy was on point. Zero issues with him. It sat for a week 45 miles from my house and I called to see if I could get it and got nowhere. I ordered 4/1 was told first full week of July and he nailed it. Not sure why it took so long to get from Cali to Washington.

 

Any recommendations on which led light pods fit the rear high clearance cutouts? (05-15)

 

In the same situation. Been trying to figure out what the best fitting pods are.

 

Looking to get the high clearance rear bumper. Just a few questions if someone could help out. I believe I saw pictures in this thread where the tire carrier is centered with the tailgate while most are offset to the passenger side, does location come down to what other additions you get added to the bumper? Also can someone send pictures of just the rear tire swing out and the fold down table? I’d be looking to get the single tire carrier swing out and fold down table depending on how it looked. Otherwise it would just be the swing out tire carrier.
Thanks in advance

 

Yooo nice wheels!
The part where your gas can holders and hi jack are connected to comes standard with the tire swing out or do you have to add that?

 

That mounting plate comes standard welded in place.

 

Just a heads up. If you do the dual swingout like I did, the fold down table is on the side of the gas can holder mount plate, and about the same size as the square, so a decent chunk smaller. nothing on the inside of the tire carrier portion.

 

Can anyone get my close up pics of their swing out latch and how it’s set up? Preferably 3rd gen

My dumbasss cheaped out and didn’t get the swing out and now thinking about building out one

 

Is anyone running a brute force hybrid front bumper with diode dynamics fog lights? If so, can you post pics. I juat bought some dd fogs and thinking they may be a little big for the mounting tabs.

 

@rdpoe has them. I don't have any photos but they seem to work OK.

 

They work great for me. Should be some pics in my build thread. Though, I'm considering making an L bracket and moving the fog lights up to the holes on the side of the plate body

 

How much and how long of a wait was it

 

Also can someone give me Billy’s contact information

 

Pm'd

 

Prices are the same as the 2nd gen bumper. I'd double check what's on the site is still valid with the prices of steel being so high.

Same for lead times.