Cap City Build & BS AF

First day back from vacation always sucks so hard.

 

trd tow hook? like the front recovery point?

 

Yes sir

 

Why? Someone install a killer speed bump at the mall?

 

i tossed

those get tossed often at the shop i used. i can grab one if i see it

 

Much appreciated good sir ​

 

Why don't you just paint it and get the thing on? Be a hell of a lot easier to maintain if you get a scratch on it. Plus when you repaint it will look new again.

 

Can you paint stuff when its 100+ oustide?

Seriously asking​

 

i agree pc gets fucked by the bushes, better to rattle can

 

Most of us use D-rings.

 

no lol not with off the shelf paint, use what pc use-- they have paint that you spray on and heat treat with a heat gun. I used cardinal paint on my rear and swingout. Its mainly for touch up but i used it on the whole thing

 

Do you think everyone stops painting stuff because it's hot outside? The paint doesn't care it just the person doing it that cares. Drying times will be a bit faster but you can do it just don't fuck around with it. Do it in the evening or in the morning when it's not so hot. It's cold you want to watch out about because it will take forever to dry. Paint that bitch and let the sun bake it on.

 

That's way too complicated. Rattle can FTMFW. Never failed me.

 

Thanks yall, Ive got everything I need to clean prep and paint....Guess its just time to buck up

 

Chadder!

 

i like your thinking.....my sliders is a Frankenstein of paint and layers added on because of laziness lol

 

I sand my sliders and bed rack down every year and repaint them. This year it's going to be sliders, bed rack and bumper. Needs to happen soon because I see primer on the driver's side slider from getting out and my boot going across the slider. It's been a little over a year since the last re-paint. Maybe 2, can't remember.

I would sandblast them but that's a pain in the ass to cleanup afterwards.

 

Sup

 

Same ole same​

 

X2. I just wipe the surface down with acetone to remove any oils or anything and then spray it. Do light even coats and they will dry faster and won't leave runs.