1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Carrier Bearing - Spicer part #?

Discussion in '3rd Gen. Tacomas (2016-2023)' started by BlackSeven, Feb 8, 2025.

  1. Feb 8, 2025 at 5:09 PM
    #1
    BlackSeven

    BlackSeven [OP] Well-Known Member

    Joined:
    Jan 29, 2012
    Member:
    #71733
    Messages:
    468
    Gender:
    Male
    First Name:
    Mike
    Maryland
    Vehicle:
    2017 4cyl 5 spd 4x4 extended cab
    Toytec Ultimate Lift kit, Toytec Rear AAL, 4.88 Gears, ARB Rear locker, Doug Thorley header, Volant Cold Air Intake, Demello Offroad front high clearance bumper, ARB On board Air compressor, BLHM, Wet Okoles, 2011 Color matched grill, Weathertech mats, 4x Innovations Sliders, ATO Engine Skid plate, ATO High lift bed mounts.
    My 2017 4cyl 4x4 extended cab 5spd carrier bearing went out, replaced it with an aftermarket part cause I couldn’t find a spicer one, it went bad within 1000 miles and is vibrating again. Assuming it’s just because it’s Chinese garbage. My truck is stock with no lift, it’s not an issue that needs a carrier bearing drop. Does anyone know the part number for the carrier bearing?? The Toyota part number 37230-09080 is 250 dollars. A complete new Driveshaft from Toyota is 580 bucks…. What the hell sense does that make? I can’t find a spicer cross over, just Chinese junk and in some cases they list the 2nd gen Tacoma carrier bearing as the 3rd gen and it’s not right (too small).
     

Products Discussed in

To Top