Changed Knock Sensors, but CEL still on?

Hello guys,

I am beginning to freak out a bit on the truck...I have a 2001 Tacoma 3.4 v6 with a trd supercharger and urd 2.2" pulley. My engine has been throwing the p0330 code which is the BANK 2 Sensor 2 knock sensor. I ordered and installed two new sensors as well as a new wire harness. I put everything back together and the CEL was still on so i figured it'd need to be cleared to relearn.

I went to OReilly's and I cleared my code there. Literally, right as I left the lot the light came on again and the truck still drives jerky as if in safe mode. I don't know what to do now. I spent 8 hours last night working on it and I dont have money to send it to the shop to fix.

Any Help would be most appreciated!!!

Mike

 

same code? plug everything in?

 

Yeah its the same code. p0330. I replaced both sensors and the harness but still the same code pops up. i have URD pulley on my charger with supra fuel injectors and 250lph fuel by the way. Do you think the sensor went bad again or is my fuel ratio just whack and its picking up the preignition?

 

And yeah everything is plugged in...it isnt tuned yet. But its so frustrating because all my power is gone...I've been running premium with it as well. In texas, it's like 91/93 octane.


Note: I also replaced the thermostat with a URD one if that means anything