Charlotte, NC area: hate on OP, houses, boats & hoes

I'm a man I can admit that!

 

Any advice on mesh wifi? I need solid coverage throughout, but especially at the Red Square locations. Considered putting Nest routers at the Green Circle locations but now I'm thinking going with a Mesh system would be better? I'm a little out of my depth here....

 

I feel that's accurate

 

I'm probably the only one that's going over the floor plan wanting to see all the build sheets. Also wondering why architects do things that are totally silly to me and irritating.

That Bedroom directly below the master could almost be an inlaws suite.

 

I think it's considered a second Master.

 

Is there Cat5/6 wire to have hard wired access points? Way better than mesh.

 

Yes that's true the upper one is technically a suite just because of the bathroom.

 

Does anyone have a guy in the area who could get some light scratches out of my paint or have the experience to help me do it themselves if I bought you lunch/beer or something?

I have some light trail stripes after the past couple weekends and going out to UHE.


I have someone and they do a great job but they are not cheap

 

Yes. What do you recommend?

 

but he didn't break down ... he got stuck, and the almighty BFG's couldn't get him unstuck.

 

Ubiquiti. How many square feet is your house? 2 levels? You might need 3 access points.

 

Ok so looks like the Dream Machine is the way to go then ad APs as needed? 2 floor, main and basement.

 

Yep, just don’t install the AP’s behind TV’s. Tv’s are basically a shield that block the signal. outdoor AP if you have Cat wire outside. Houses are built so well these days WiFi signal has a hard time getting through the exterior walls.

 

https://store.ui.com/collections/unifi-network-routing-switching/products/unifi-dream-machine

 

Yeah I'm planning to drill through the exterior wall so I can put an AP in the back for the pool and boat dock.

 

Spend the extra money and do it right. https://store.ui.com/collections/unifi-network-routing-switching/products/udm-pro

 

Get a random orbital polisher (recommend a FLEX but $$$) there are cheaper ones on the market.

Get an orange pad and some Meguire's 105 and 205 from HF...then hand wax with whatever you want...tons of wax on the market.

Griots Garage has whole kits you can buy as well, they make good stuff.

 

Believe there is a detail shop in Southend somewhere too, they could probably hook you up with products.

 

Thought this got covered up. Yeah, I've seen Go-Bys on how to do it just not confident enough to do it myself. I'm nervous to take off to much of the clear coat. I think If I did it one time with someone's help I would be less hesitant the second time.

Yeah the detail shop is right by my neighborhood.

I don't care for it to be perfect but a few of them are pretty bad. This past weekend was nasty