Clearance on 16x8 -10, 265/70 r16?

Stock tire size but will the offset create a rub on anything? So frustrating trying to find someone running this setup and to know if they rub

 

I suspect you would be fine but I can’t say with 100% certainty. I used to run 265/75/16’s with a 1.5” lift up front, 16x8 wheels with a -10mm offset. They were no where near rubbing and lift really doesn’t correlate to no rubbing unless you’re talking about hitting the top of the wheel well while cycling the suspension. It might be close when you’re at full lock.

I’m currently on 285/75/16’s, same wheels… 16x8 with -10mm offset.

 

I had no rub anywhere when I had 265/70r16 tires on stock wheels, 16×7", +25 offset, running 1.5" spacers. That is -12 offset equivalent.
You'll have slightly different with 8" wide wheels. Run an offset/backspace calculator to see the comparison.

 

Do you have any rubbing with your current setup?

 

with my current 33’s…yes. In one very specific condition… very very slight rub at ~75% turn while in reverse, turning the wheel counter clockwise. And it’s only the driver’s side tire.

 

Wow, thats quite specific lol. So no rubbing when off roading at all?

 

lol yeah it almost never happens and I could easily fix it with minor trimming if it was an issue.

I rubbed once off road in glacier National Park when I bottomed out my suspension on a washboard road, but that was the only time.

 

Alright I see. Sorry one last question, what brand are your tires from? I see lots of people run these same specs but some rub a lot and some don’t, so I”m trynna see if there’s any correlation with tire brands.

 

My wheels are from Black Rhino. I highly recommend them, I’ve had them for several years and about 70K miles and they have been fantastic.

 

Thank you! Sorry but i meant the tire, not the wheel itself.

 

Whoops! I misread that, my bad. My tires are the Yokohama Geolandar AT4’s.

 

Thank you!

 

Anytime