Co fab shops

I wish. Get a toyota axle under there with a frame height equal to or less than 23"...

 

Sub,

I am in need of sliders soon. Rear bumper someday.

 

Does your bumper tie into that cross member with the strap/tow hook on it? If you chop that piece off just below where the crash bar mounts and weld in a new higher cross member will the bumper still work? looks like the case with your solid axle but I can't fully tell

 

on my truck i did cut out the cross member and raise it up to the frame horns, this did add 4 inches to the clearance point there but you would have to have a custom skid plate built if you went that route. the ifs bumpers will accommodate the factory recovery point if needed or you can chop it off.

jake

 

Had some sliders made from AOF. Exactly what I wanted. bed rack made by him too. Awesome quality stuff!

 

Hey Jake, I sent you a PM.

 

So effing sick man!

 

Thank you!

 

So so SOOOOOOOOOO much wants!

 

I do have a high clearance rear bumper thats going to be built and brought down to Amarillo here in the next month or two.

 

The post reply button is useless unless you hit it

 

I love the look of the bumper on that red 1st gen! Do you guys make anything like that for 2nd gens?

 

We can definitely make one for a 2nd gen for you!

 

Hey Jake do you think you can fit in the new mount for my fly rod carrier before the 25th? I could leave work early and open up a weekday time too if it would help.

 

Pm inbound. ​

 

Hey Jake, do you have any good pics of your rear...bumper that is?

Your build thread was too d@mn long to dig through

 

Dud stop looking at his rear! That's just creepy

 

@3378jakesr5 can you show a pic of your trucks rear?

Asking for a friend

 

Hey this is a business thread! Lets keep it classy ha?