Colorado B.S. Thread

4 fires within a few days.. Really hoping this isn't arson. Yet it is super dry so not too surprising

 

There’s no lightning in the area. At least not here in Boulder County.

I hope it’s not assholes throwing their lit cigarette butts out the window of the vehicle.

 

U can bet that all the fires above are Human Caused - we are a stupid species.

 

You can't print a tool to press in a magnet?

 

I'm bringing over my Made in Japan hammer.

 

I has an arbor press, hydraulic press and drill press. No need to print things that already exist in nature.
I figure a short section of round stock in the drill press to stick the magnet to, then run it home with the wheel.
Smashing them in with a hammer and block of wood might work well and be rewarding too.

 

That is what thumbs are for

 

I just read that post to this melody.

https://youtu.be/6A2WQksCSWI?si=o0klQFDfD4rx2FqI

 

This made me think of Deep Purple

 

Any Tundra bros on here that have recommendation for HD rear leafs (tow a travel trailer a lot in the summer and fall)? My hooptie needs a butt lift.

 

Are airbags not a good option? If I had a variable load, I'd do bags.

 

Tired of them not holding air. And factory leafs have 250k on them…

 

I trust Jason’s recommendation but am in the same boat!

 

Its my friday! you should all be happy for me

 

Rockies picture with the dagger trash talk.. this made me laugh and the fact the Quantrill was ready to use it as ammo is hilarious.
https://www.youtube.com/watch?v=qQqb_l0Y7Ak

 

Were the bags themselves leaking or the fittings and tubes?
Mine only leaked at first when I rushed the fittings, they only held air for 5 days at most. After using thread tape the proper way, and making sure all my cuts were flush and clean I haven't had any problems.

 

https://activesuspension.com/

 

Magnets are in.

I can either head up tomorrow afternoon or any time on Sunday.

Let me know what's best for you.

 

Either is fine with me. Sunday morning if you want to avoid the heat.