Colorado B.S. Thread

I'm the only one that can park....

 

On Deadpool

 

I can't wait, going to see it tomorrow

 

IT IS SO DAMN GOOD!!!!

 

I second this I saw it today as well! Caught a early showing today wasn't too packed cheaper too. Make sure you stay till after the credits

 

Yes. Wait tell the lights come back on, it's worth it.

 

if i only had a home with equity to take out a HELO

 

I saw a nice cave in Moab the other day.

 

i wish..could build a back ass garage cave too!

would need a lot more solar panels than those guys had tho

 

YO!!!!! Hey gents I'm having some wobble in one of my new wheels. I took it off and and checked the lug nuts and wheel studs and they looked fine and then measured the drum around the center piece and it was a little off. I beat the drum to try and seat it better. It lined up a little better. I put the new wheel back on and it still wobbled. I took it off again and rolled it around the garage and noticed that the tire rolled with a hump on the tread. Would that hump in the tread cause the wheel to wobble?

I put on one of my stock tires and drove around. It moved a little bit but but not as much as the new one. I know my rear axle housing is bent to shit because of the abuse it's been though. I was wondering if someone had time to throw my tire on their truck to see if it wobbled on their truck. Let me know if you can. Because if it's the wheel....... someone at method owes me.

 

swap it with another on your truck and see if the wobble goes with it

 

Want to do the Taco antenna swap on my Runner now? The motor is driving me insane!

 

I'll give it a shot. My passenger side seems to drive pretty straight with the wheel it has now. I'll throw it on there. I just wanted to throw it on a truck that didn't have a bent axle housing.

 

@thefatkid, the parts were ordered by VIN#, this gasket was included, the pics show it going in this location but I did not have one on it when it was removed.
Plus, it doesn't seem to seat against anything...should it be ok to leave out? Or should I just let it ride on the shaft?



Looking at this pic from another, it appears it's for a different kind of cooler?

 

Went to hand wash my truck and decided it's still too cold lol.