Colorado B.S. Thread

What is that?

 

Chainsaw????

 

Oh yeah I see it now.

 

What clutch did you go with? I have ran an ACT for the last 80k, but it's starting to slip when driven hard. I bought a marlin, I'll see how it holds up to the SC and 315's .

 

Sorry friends...i lived, my estate will not be parting out the truck. Maybe next time.

I peeked up and saw a little of the sunrise! It was so quiet, didn't hear any critters creeping around at all.

 

That's called necrophilia, and i do not approve of that.

Damn Californians.



You done with your road trip yet?

 

Californians get isolated from all the good stuff by the politicians and hippies, so they have to do something for fun

 

Almost. Gonna hang out in moab for the day then be heading back.

 

TOTW. For those of you who have seen my truck could I make it? Everything online just says "moderate difficultly" which doesn't tell me much.

 

Yes... be ok with some frame scraping, and I have not done the left side of the lolipop at the top (its supposedly a little more difficult). (When going up, you'll stay right at the fork) You have a spotter, which I did not have when I did it alone.

Its a slow climb, but awesome at the top.

Worst case, you'll have to stack some rocks. Just make sure you dont squish your exhaust on any of the ledges, mine came close after I slid off the rock I was shooting for.

There was also an area where there are some decent ledges going straight, and a bypass to the left. The "bypass" is a steep climb up, but that has a good ledge at the top that was rutted out (and I was not feeling backing down). In the end, I remembered that I had a locker and got up it.

 

Anyone have a set of 86-95 Toyota IFS front snouts and hubs they want to sell or trade?

 

So I want to put a dog door in my back door which is metal,
Will a jig saw work well for this??
I suppose pulling the door off the hinges and putting it on some saw horses would be a better option??
Any pointers?

 

Yeah figure out where you want it, pull it off mark and measure a few times. Drill holes in the corners and use jigsaw/sawzall/grinder to open it up.

 

Thank you

Hahaha if I don't F--k it up!!

 

even still

 

Ok either way!!!