1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Combining stock leaf packs

Discussion in 'Suspension' started by '14RC, Dec 2, 2019.

  1. Dec 2, 2019 at 5:09 PM
    #1
    '14RC

    '14RC [OP] WA State

    Joined:
    May 18, 2016
    Member:
    #187279
    Messages:
    261
    Gender:
    Male
    Seattle
    Vehicle:
    2014 4x4 Regular Cab 5MT
    2" Lift & 32" tires w/ Camping Setup (see details) Suspension: Dobinson 2" Coils (PN: C59-316) 4x Bilstein 5100's (base setting) SPC Upper Control Arms Deaver J66 Leaf Springs Ride-Rite Airbags Archive Garage Hammer Hangers Poly Leaf Spring Bushing Camping: SnugTop Canopy ARB awning Built a Camping Shelf in the Bed Yakima Mega Warrior Roof Basket Interior: Bucket Seat Conversion Acoustically Insulated Interior Added Cruise Control Rear Storage Organizers Traction: Yellow Wire Mod Alloy's with 265/75/16 Towing: Aftermarket Class III Tow Hitch Trailer Wiring Brake Controller (wired, not installed) Misc: ECGS Bearing NH Oil Undercoating
    Evenin' TW

    For those who have experience building leaf packs, I'm wondering if I could take the bottom leaf (not overload) from a 2nd or 3rd gen Tacoma and add it to my stock pack?

    Had a 3-leaf AAL and I didn't care for the stiffness of it. I know this idea wouldn't lift the rear other than the thickness of the leaf itself, but would add some load capacity and keep the ride quality decent.

    Specifically, I'm wondering about having two leaves that are the same length stacked on top of each other. Okay or not okay?
     
    Last edited: Dec 2, 2019
    MDunk and MARK4A3 like this.

Products Discussed in

To Top