Cross member not lining up

So my buddy and i installed a new clutch into my 06 4x4... and while putting everything back together, my crossmember won't line up with the transmission to put the 4 side bolts in... i know you need them there. I tried switching the crossmember around, no success... any help would be great. the truck runs fine, switches all gears well. did a test drive around the block, and over to my buddy's garage... can't figure out what is wrong. any advice would be great.

 

it's about 1/8 inch off and back too far will try and upload a pic, but not technically inclined. itried moving the end of the trans up and down, and the engine... doesn't get any closer.

 

pictures would be helpful if you can get them

is the truck on jackstands?

 

no jack stands. lines up on the right angle... just half the screwhole is visable... probably just need someone to push it that little bit forward...

 

noob award goes to me... good old flathead worked to move the croosmember over that little bit... :-/

 

God help you if you ever need to replace a leaf spring.

 

eh, as long as it's back together, that's all that matters right?

 

well i did see that leaf spring squeak thread... :-D