Custom Fuse cover- Extended Height

This drop is the first. Get you one!

 

Ok, I didn’t see it mention on the in stock post. I’ve been swapping the 3D for mold as they come

 

Mine has already shipped!

 

Heads up, I have a 2018, I don't think the label is correct, It's missing the Towing BRK NO.2 Was going to just use the other one, but the 2019 label has the washer at 20A while the 18 is 10A

 

Thanks for the heads up, just checked mine and you are correct. I'll probably just cut out the Towing BRK NO.2 and stick it on top of the other.

 

Got mine this morning and checked the original against the two stickers. Same for my 2018. The 2019 also has a 7.5A USB instead of the 2018s 15A poutlet no2. I just cut the Towing brk out of the 2019 and put it on top of the blank spot on the 2016-2018 sticker. It's barely noticeable since it's so tiny and it'll be under the dash anyway.

 

Finally got one. Order #24300

 

Installed, looks great. Great idea

 

Got mine in as well. Thanks for a great product buddy!

 

Thanks guys. So I was going off my 201( fuse which has an “X” on that spot.. seems like some 2018’s started putting a fuse there. I tried to cover all years/models/config’s but seems that even the same years trucks can be different (maybe trim models) I’m starting to gather a database of what fuses configurations there are and might make
Some more sticker versions. Worst case, you can cut the 1 fuse label from the other and apply it to yours.

Aweosme!

 

pm’d

 

Got mine a couple of days ago. Installed today. Very nice fit and finish. Thanks sir, now just not sure what fuse taps I need to add for, but looks better than OEM, and easier to access. Great job on this product MESO. I have no idea how the factory can have that cheap cover on there, it felt like it was going to break off when trying to remove it after removing it, you can see where the stress of removal showed on the OEM cover. I leave it in the console box as a reference for the fuse locations.

 

I was trying to remove my OE cover to replace it with this one and it wouldn’t budge. Do I need to use a pry tool or screw driver? Thx...

 

I used a screw driver in the tab.

 

Thx! I’ll try that.

 

I forget which direction to pry, but it was pretty difficult.

 

@MESO I just got one of these and put the 2016-2018 sticker on based off the year. Probably should have looked first, but on my 2018 there is definitely a fuse in the unmarked spot. Seems like the 2019+ sticker aligns better with it.

Just wanted to share and see if I was being dumb.

 

The WASHER fuse doesn’t match up.

 

Good catch. I didn't even notice that. Sooo neither match my truck .

 

Little cut and paste is all you need