1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Diamond plate bumper ?

Discussion in 'Relentless Fabrication' started by Brett C, Feb 14, 2011.

  1. Feb 14, 2011 at 9:29 AM
    #1
    Brett C

    Brett C [OP] Active Member

    Joined:
    Feb 14, 2011
    Member:
    #51138
    Messages:
    34
    Gender:
    Male
    First Name:
    Brett
    Edgewood Tx.
    Vehicle:
    4x4
    Could you make one out of diamond plate ? I have one on my Dodge that is pretty good .
     
  2. Feb 17, 2011 at 9:11 PM
    #2
    RelentlessFab

    RelentlessFab Tacoma offroad armor fabricating beast Vendor

    Joined:
    Feb 17, 2008
    Member:
    #4772
    Messages:
    14,634
    Gender:
    Male
    First Name:
    Eric
    Eastern side of the Sierras: Sparks, NV
    Vehicle:
    07 SR5 6mt to 03 SR5 to 08 Sport and 17 6MT TRD OR
    Relentless Armored! Too many others to list.
    Steel or aluminum?
    In short, yes I can.... it would be pretty unique. Not my thing, but its possible if you're interested.
     
  3. Feb 23, 2011 at 12:06 PM
    #3
    Brett C

    Brett C [OP] Active Member

    Joined:
    Feb 14, 2011
    Member:
    #51138
    Messages:
    34
    Gender:
    Male
    First Name:
    Brett
    Edgewood Tx.
    Vehicle:
    4x4
    Would the cost be the same ?
     
  4. Feb 23, 2011 at 12:21 PM
    #4
    RelentlessFab

    RelentlessFab Tacoma offroad armor fabricating beast Vendor

    Joined:
    Feb 17, 2008
    Member:
    #4772
    Messages:
    14,634
    Gender:
    Male
    First Name:
    Eric
    Eastern side of the Sierras: Sparks, NV
    Vehicle:
    07 SR5 6mt to 03 SR5 to 08 Sport and 17 6MT TRD OR
    Relentless Armored! Too many others to list.
    It would be or very close to it if were talking steel- im not sure if I could even get alum diamond plate that thick. Just so were clear, all external welds would be left alone on the diamond plate because of the pattern preventing me from smoothing them down. I think the welds would be nice enough looking that it wouldn't kill the look of the bumper though.
     
  5. Feb 24, 2011 at 8:35 AM
    #5
    Brett C

    Brett C [OP] Active Member

    Joined:
    Feb 14, 2011
    Member:
    #51138
    Messages:
    34
    Gender:
    Male
    First Name:
    Brett
    Edgewood Tx.
    Vehicle:
    4x4
    Cool thanks I will keep that in mind.
     
To Top