Does anyone make make a bed mount for a cb antenna?

Well, do they?

Like bed rail mount, not tailgate. I'm looking good to put a cb antenna behind the cab on the bed rail.

Thanks!

 

I've seen 1 on here somewhere. I believe rago fabrication does. If not just get a piece of light 2" angle and drill 2 holes for mounting bolts on 1 side, then drill a hole for the antenna to mount on the other. If you want to get fancy you can trim the antenna section to whatever size you want.

 

Here you go
http://www.relentlessfabrication.com/collections/toyota/products/05-tacoma-bed-rail-mount-tab

Just need to run a clean ground

 

BAMF
http://www.bayareametalfab.com/Bed-Rail-CB-Mount_p_54.html

 

Cool thanks for posting that and for the ground info

 

Thanks all!

 

+1 on the @RelentlessFab mounts! I think the only part of the truck that may be as stout as these brackets might be the frame. Bought a set on Black Friday, but haven't done the install yet... debating on going to ditch light brackets instead.

 

Stop by any truck stop.

 

I'm not sure how the 3rd gen bed rails are but for about $15 (because you have to buy a 4' section of aluminum) you can make your own. 2 carriage bolts + nuts, 3-4" of 1x1 angle aluminum and done. Threw a firestik on mine and was almost perfect on the SWR. Ask @ForeRunner how much of a surprise that was.

 

^^^this!

I bought this one and love the way it looks. Didn't run a ground to it though I can hear traffic but I can't get out very far. I gotta go back and run the ground

Paired it with a 3' Firestick antenna.

 

Yup! I just bought one of those as well! Along with a hi lift jack mount!