1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Down O2 sensor replacement wiring harness HELP

Discussion in 'Garage / Workshop' started by Lauka_jm, Jun 29, 2019.

  1. Jun 29, 2019 at 3:22 PM
    #1
    Lauka_jm

    Lauka_jm [OP] New Member

    Joined:
    Jun 29, 2019
    Member:
    #297811
    Messages:
    1
    Gender:
    Female
    First Name:
    Lauka
    Vehicle:
    2001 taco TRD 5spd
    heyo. I’m tryin to replace the O2 down from the cat. I’m wondering where the hell I find it’s connection to the wiring harness. Before I tear shit apart, anyone have some advice? How much of a pain is this going to be? I’d rather “do it right” rather than splice the wires for the new sensor under the truck. The wires go up into the floor panel. Where next?
     
  2. Jul 3, 2019 at 3:06 PM
    #2
    Wyoming09

    Wyoming09 Well-Known Member

    Joined:
    Apr 24, 2015
    Member:
    #153833
    Messages:
    14,277
    Gender:
    Male
    New Tripoli Pa
    Vehicle:
    2000 Work truck 5 speed 4x4 3.4
    Super Springs
    The connector should be just on the upper side of the rubber grommet .If it is the original set up

    Your new sensor if the correct one should have the new grommet attached
     

Products Discussed in

To Top