Drive cycle/ OBDII codes

When I got the truck rolling I went to DEQ to get my tags renewed, without checking the codes first (dumb). Assumed I’d pass because I had no CEL.
Came back with a P0031, replaced upstream O2 sensor / air/fuel sensor with the correct Denso
Now I have Evap System incomplete in my drive cycle. I’ve been following a couple different threads about how to complete the drive cycle.
Anyway, yesterday afternoon it showed complete in my torque app, so I checked logged faults and got
P0441
P0442
P0446.
Did some quick research on here and figured I’d better pull the bed back off this weekend, but this morning it’s back to Evap System incomplete.
Weird? Why would it say the drive cycle was complete and then go back? I didn’t clear any faults.

 

I had the same thing happen with those EVAP codes.
When the purge Selnoid worked properly I got completed drive cycle even though it had stored codes for a single fault event.
It takes 2 fault events to get CEL.
I replaced vacuum hoses and purge Selnoid for the fix

 

Thanks, that’s good to know.