Duratrac on 2nd gens with 3" lift

looking at putting on duratrac 285/70 17 on 17/9 12mm offset 4.50 backspace wheels. Have OME front lift, dakar leafs and spc uca's. Prob gonna have to CMC but am gonna run into any rubbing?

 

Probably.

 

Probably at full lock but nothing minor trimming couldn't fix. I went with 265's to avoid this

 

If you don't mind trimming I think 33's look better

 

Hmmm like something the heat gun could fix?

 

I have 265s and I rub my JBA UCAs at full lock

 

If it's plastic.

Go for it.

 

33s i would prefer. Just wanna know what ill be hacking off. Before i go buy the rubber.

 

Wheel offset issues. 265s shouldn't rub.

 

Nothing you couldn't go without

 

Plastic and metal. No big deal.

If you're cool with a CMC you won't mind trimming a half inch of fender liner.

 

It's stock OR wheels. I think it's the UCA design. Never compared to stock UCAs

 

Must be. Bummer.

Try some spacers or higher offset wheels.

 

The cmc im fine with. Fender liner works sounds like not much fun

 

Box knife fix.

 

Yessir, got some 1" BORA spacers coming in!! Gonna really give it a good stance

 

Make sure you torque them properly and recheck every so often.

Decent enough torque wrench can be found for $30 on Amazon. Tekton brand.

 

I like the way you think, that's the exact one I use haha

 

That right there seems to be the big thing with spacers (good ones). torque them properly. I have spidertrax I have been running for 3 years and have probably ~70K miles on them with no issues.

 

Depends on the activities you will see. I have 285's with OME and LR UCAs and I did a CMC, removed mud flaps, trimmed the plastics near where the mudflaps mount, cut away the plastic covering the pinch weld and flattened that too. Still could use some trimming on my front liners/where the mudflaps mount..It's never enough