1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

FiberGlass Inside Tailgate, 2nd Gen Taco

Discussion in 'Detailing' started by PacoTaco, Jun 3, 2011.

  1. Jun 3, 2011 at 7:00 AM
    #1
    PacoTaco

    PacoTaco [OP] New Member

    Joined:
    Jun 3, 2011
    Member:
    #57666
    Messages:
    2
    Gender:
    Male
    CENTENNIAL, CO
    Vehicle:
    SR5 SHORTY
    STOCK
    Hey all, just was working on a dent from a trailer handle just above the latch.

    Tried the good ol' glue puller, got most of it but a little dimple that would not give up.

    Decided to take off the inside panel and attack from the inside, but there was this fiber material on the inside that I had to work through to push out the dent.

    Now that I am done, and I tore up the fiber material, should I be concerned that stuff will take on moisture and be a potential rust point, if a yes, what can I do to fix or minimize that??
     
  2. Jun 4, 2011 at 1:57 PM
    #2
    BUZZCUT

    BUZZCUT Well-Known Member

    Joined:
    Mar 6, 2011
    Member:
    #52417
    Messages:
    734
    Gender:
    Male
    Georgia
    Vehicle:
    2021 TRD OFFROAD 4x4
    Fiberglass won't wick moisture. Mix up some resin and lay them back bown
     

Products Discussed in

To Top