Finally started wrapping my interior!

Think I could do most of that with 60" 3' or 6'??

 

Oh ya man I only got 1'x5' and I still have a ton left. Just maximize each cut you make and make each piece count. Glad I inspired a fellow member. Putting it on small pieces here and there definitely gives it a tasteful touch IMO

 

Ahhhhh-hahaha!! That picture says just about what I was thinking when I read his explanation!

 

Looks good, OP. Sub'd for installed pics. Adding to the list of future mods.

 

Alright guys as promised here are the install pics

 

You missed a spot... The vent surrounds. Looks good tho, way different

 

Still not sure if I want to tackle that yet... Dont want to do too much. Still not sure on the center and upper consoles either

 

Just ordered wrap and heat gun. Thx for inspiration lol

Are you gonna do the stereo bezel? Also, did you spray any extra adhesives?

 

Lol no problemo. Idk bout the stereo yet, still trying to find some more pics. No spray

 

did you hit the silver around the tweeters on front doors? i can't recall from installing my speakers if those pop off separately from the wire mesh. i'm gonna start with door panel controls, AC panel, and maybe steering wheel. for the drive shaft, did the plastic just pop off there or did you cut around it? same question for steering wheel plastic. thanks again for the information.

 

I haven't done the speaker yet, still debating on that one, but will probably do it. Everything I wrapped was removed, no cutting. Steering wheel has two torx on the side of wheel, loosen those then lift air bag off to reveal bolts holding down the trim. Steering wheel is my favorite so far

 

looks awesome! was considering doing this also.. i just gotta find the time..

 

Right after work brother! Instead of the hour of tv before u go to bed, work on a piece here and there

 

Does that silver plastic piece on the shift knob come off? Or did you wrap without taking it apart?

 

one more question until i think of more... besides wrap and heat gun, any other tools you use? can i cut the wrap with scissors or a buck knife? or should i use a razor?

 

Sick bro. I actually have some cf wrap on the way as well. I will be doing all of the interior that will allow. But not go overboard or anything. Just important things. I hope the blow dryer works well cause I don't have a heat gun and this is going to be my first time using it

 

Looks good op!
Are you going to do anything about the volume control on the steering wheel?

 

I have been so interested in doing this but have no idea how to get the parts off!

 

Any way to do it without breaking anything?

 

ok to do this indoors? or will i get high off the fumes? planning on doing this on a desk in my office.