1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Flare nut questions

Discussion in '2nd Gen. Tacomas (2005-2015)' started by wilson23, Jul 18, 2020.

  1. Jul 18, 2020 at 3:16 PM
    #1
    wilson23

    wilson23 [OP] Well-Known Member

    Joined:
    Nov 11, 2013
    Member:
    #116377
    Messages:
    123
    Gender:
    Male
    I recently bent my rear axle housing so replaced it with a trail gear fabricated housing. I need to make some new brake lines to follow the lines of the housing and clean a couple things up. This is new territory for me and thought i was set with standard M10x 1.0 flare nuts but then read a thread that Toyota, in some cases, uses a shouldered flare nut that is tough to source. anyone have experience with this?
    here is the thread that through me for a loop:
    https://forum.ih8mud.com/threads/after-market-flare-nuts-10mm-to-toyota-fittings.1063724/
     

Products Discussed in

To Top