For Stock Rigs Only

If you say so..

 

I could pay $8 for a damn nasty fair corn dog. Or $11 for 2 tacos, corn and a cold Pepsi. No brainer

 

Ahh Gee that’s funny as shit..

 

In 2.5 years and 23k miles it's her first scratch or dent anywhere on the thing. So I can't really complain.

Frankly the incline was stupid steep and there were 4 of us plus a trunk full of luggage. So she was probably sitting a little lower than normal....and the wife came into a little hot too. Kinda of a perfect storm.

I sanded the area down smooth and masked off that entire side of the bumper cover and headlight. The Duplicolor can lays down the paint pretty good. Lori was happy.

 

Had a nice time tonight with my 13 year old at the fair. We don't get a chance to get out like that often enough. Good times ♡

 

Gotta have them now cause when the adult part kicks in it’s never the same

 

@Plain Jane Taco can't go wrong with deep treads IMO

 

Mornin’ stockers. Hope all is well. Got off the grid for a few days mid week. Tacoma in service mode.

before we travelled I knocked out an oil change. Found all 5 zerks for lube (thanks @Delta09) but only hit 4 of ‘em. There are two on the front drive shaft. The one closest to the differential is tucked behind a heat shield above the exhaust crossover. Could not get to it without dropping the heat shield. Being the dumb ass that I am, rather than an impact to crack the corrosion, I grabbed a breaker bar and that 12mm head popped right off.
Now I’m looking at liquid wrench/heat/ easy out to get the shield off and replace the bolts so that I can lube that zerk regularly and keep those threads corrosion free.

 

Fridayyy!

 

Yeup
YOUR RIGHT AGAIN.

 

Digging new 4' deep footings in clay with existing posts in place....good times.

 

Here's that small deck/porch I did last week. Still waiting on the stainless steel cable railing parts to arrive.

 

Well that looks like it sucks…

 

That would be correct.

 

Hoping everything lands nicely on the footings when I head over later this morning to lower the jack and remove the blocking. Have some shims just in case.

 

Grease gun with flexible hose will access that zerk w/out removing the heat shield.

 

Yea shims are your friend.

(psssst , don’t forget the cement… )

 

i was down there with said flex hose and couldn’t get to it. I’ll give it another go

 

I believe I access the zerk towards the top. Have to kind go at it with an angle.