For those with a shell, do you wish the TRD stickers were lower?

I'm seeing quite a few pics of 3rd Gen trucks with shells/campers where the side of the shell seems to go right up against, or even slightly cover the TRD stickers. Does it bother you? Just curious

 

Wouldn't bother me a bit more than the truck not being 'level'. Of course in my case the stickers would have been long gone anyway........

 

Know what you mean...looked at shells for a while before I went the cheaper route and got a tri fold tonneau cover....it bothered me on a lot of the tops I saw...if I would've put one on I would've peeled the stickers and ordered new ones from factory

 

I've never cared much for vinyl accents & decals. Much prefer a clean understated look. I was also concerned the vinyl would eventually fade, crack, or peel. Early on I removed my TRD decals, along with the vinyl strips between the side windows. Later, when I had the cap installed, it just made the truck look complete.

 

Take those lame stickers off! You will be much happier !

 

I'll probably take the stickers off when it warms up outside.

 

Doesn't bother me at all. I'm very happy with the look of my truck with the topper!

 

Looks good. Specs on the topper?

 

My stickers line up fine with my topper.

 

What brand is this? This is like!

 

Leer 100XR, sliding windoors, sliding removable front window, headliner, rack

 

No decals.

 

ARE Z-Series.

 

I've spent a lot of time looking at caps for the '16 and it looks like the ARE and Leer caps don't interfere with the decals, but the snugtop ones do.

 

+1

 

Correct

 

If you like the bedside decals but not the location once the caps on, some guys get custom decals made n you can place them wherever you want
https://www.tacomaworld.com/threads/custom-made-vinyl-stickers-bedsides.281228/page-126

 

Pulled my decals pre canopy:



Had I wanted to leave the decals, the canopy coming to close to them would have driven me nuts and I would have likely ended up pulling them anyway.

 

My tonneau cover cuts about half of the sticker off. I bought new ones from Toyota. I am going to lower them about an inch and a half

 

Leave them on, take them off, put them back on again ... repeat as needed depending on which way the wind blows ... the decals cost $10 each on Ebay, so do whatever suits you best.