Fox 2.0 Front Coilover Adjustment Height Dimensions

Spent a hour or so browsing through Fox 2.0 threads trying to figure out how much to adjusted these for around 3" of lift with UCAs. Finally found some arbitrary X amount of turn measurements so wanted to just throw them here with dimension incase anyone else was in my boat and looking.

Was said you needed to add 6 turns on the passenger side and 9 on the drivers to account for lean.

Starting measurement from the bottom of the threads to the bottom of the adjustment ring starts at 2-3/4" for the 2nd gen +2" of lift. (This will only be +1 for a 3rd gen)

6 turns for passenger side ends at 3-5/16" Added .5625

9 turns for driver side ends at 3-7/16" Added .6875



Hope this is helpful for someone else down the line.

 

Very helpful... Tough to find such specific data on collar changes... Just what I needed.

 

You dont even know my frustration when I was trying to find it. I ordered 700lb springs for this since I have a bumper and sliders now. Turns out accutune says they use a 3" spring just like the 2.5" coilovers

 

Do you have a pic of when you measured. Bottom of thread to top of collar?

 

I did not, ive also swapped my springs out for heavier ones since then.