1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Front end clunk

Discussion in '2nd Gen. Tacomas (2005-2015)' started by rpktaco, May 13, 2021.

  1. May 13, 2021 at 4:40 PM
    #1
    rpktaco

    rpktaco [OP] Well-Known Member

    Joined:
    Feb 24, 2015
    Member:
    #149519
    Messages:
    51
    Gender:
    Male
    nj
    Vehicle:
    05 sr5 trd
    I have a low speed clunking noise which turns out to be a endlink i’am going to replace them with oem ones and the sway arm bushings do they go on dry or with grease ?
     
  2. May 13, 2021 at 4:44 PM
    #2
    Bishop84

    Bishop84 Well-Known Member

    Joined:
    Dec 17, 2015
    Member:
    #172494
    Messages:
    12,056
    Gender:
    Male
    I use a very small amount of Sil-Glyde on sway bar bushings. Any non-petrolium based is a good idea to use a small amount.

    Be careful with the bolts that hold the sway bar to the frame, they can break, make sure to lubricate them or replace them if they are rusted.
     
    Key-Rei likes this.
  3. May 14, 2021 at 3:42 AM
    #3
    rpktaco

    rpktaco [OP] Well-Known Member

    Joined:
    Feb 24, 2015
    Member:
    #149519
    Messages:
    51
    Gender:
    Male
    nj
    Vehicle:
    05 sr5 trd
    thanks i tried to order new bolts when i purchased new bushing but where out of stock till 26 going to try my local dealer.
     

Products Discussed in

To Top