1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Front End Humming

Discussion in '2nd Gen. Tacomas (2005-2015)' started by OzarkRider, May 2, 2024.

  1. Jun 8, 2024 at 1:47 PM
    #21
    stayalert

    stayalert Member

    Joined:
    Jun 13, 2010
    Member:
    #38892
    Messages:
    12
    Gender:
    Male
    Vermont
    Vehicle:
    2010 access cab Taco with 2.7L 4 cyl. egine and manual trans.
    front receiver hitch from 4x innovations
    Any tips on removing the 4 17mm bolts that hold the hub to the knuckle? I have new assemblies to install but the first bolt I put an open ended wrench on wants to round off the bolt.....I am low on propane for my little torch maybe I need more heat????

    Alternatively....Because I have new pre-pressed assembly is there a way to remove the old flange with the wheel studs so I can access the bolts with a socket?

    (2010 4WD front wheel bearing replacement effort)

    Rob "not very alert" M
    Norwich VT
     
  2. Jun 9, 2024 at 3:51 AM
    #22
    mrlee

    mrlee I like crunchy Tacos!!

    Joined:
    Sep 13, 2015
    Member:
    #164166
    Messages:
    883
    Vehicle:
    2013 TRD Sport (Yeah, it's gotta skewp, Haterz gonna hate)
    Bed rug, ARE bed top, Weathertechs. Little goodies here and there!
    Mine is humming and goes quiet when i swerve right. I replaced the front right and hum still there. Which side did you replace? Thinking of doing left side
     

Products Discussed in

To Top