1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

front end jack point

Discussion in '1st Gen. Tacomas (1995-2004)' started by ZanderD, May 5, 2010.

  1. May 5, 2010 at 7:06 PM
    #1
    ZanderD

    ZanderD [OP] New Member

    Joined:
    May 5, 2010
    Member:
    #36615
    Messages:
    3
    Gender:
    Male
    First Name:
    Alex
    IN
    hey guys iv owned my 01 4x4 Tacoma MT sr5 for 4 years now, all iv done to it is tires, spark plugs, engine oil, trans oil and fluid top offs, and it runs great, but i still haven't had to put new brake pads on it, the brakes are still working very good but i want to put new pads hardware and rotors on it just to sleep good at night :). i was wondering do i need to take off the skid plate to jack up the front end, and is that circle that is stamped into the skid plate were the cross member is, and is that were i need to jack at,
     
  2. May 5, 2010 at 7:08 PM
    #2
    chris4x4

    chris4x4 With sufficient thrust, pigs fly just fine. Moderator

    Joined:
    May 8, 2008
    Member:
    #6497
    Messages:
    106,192
    Gender:
    Male
    First Name:
    FlimFlubberJAM
    Tenoe, AZ
    Vehicle:
    2013 Rubicon Unlimited,
    4.10 gears, sliders, and lots of buttons.
    Welcome to TW!

    Here is a diagram to know the lift and support locations.
     
To Top