1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

FS: 1984 Toyota 4x4 Pickup Hunter's Dream - $2950

Discussion in 'Buy / Sell / Trade' started by neontrail, May 14, 2009.

  1. May 14, 2009 at 1:50 PM
    #1
    neontrail

    neontrail [OP] ✈ ✈ ✈ ✈ ✈ ✈ ✈

    Joined:
    Apr 9, 2008
    Member:
    #5844
    Messages:
    10,109
    Gender:
    Male
    Idaho
    Vehicle:
    2004 NISSAN XTERRA XE/SE
    De-badged, Tint 20%, Blue 48 LED dome-light, .......
    NOT MINE, but found this ad on craigslist..... WHoaaa

    $2950

    [​IMG][​IMG][​IMG][​IMG]
    I bought this 1984 Toyota 4X4 Pickup about a year ago as a project/hunting truck. I do not have the time to enjoy it the way I originally intended. So far it has been a good truck. In the past year I have done quite a bit of work to the truck including:

    - rewired all the lighting
    - wrapped in west texas camouflage
    - bottom end of motor rebuilt 10K miles ago
    - new carburetor
    - new radiator
    - 33 inch tires
    - installed bucket seats and a center console
    - applied a protective coating similar to rhino lining on the dash and on the floor
    - replaced the rear axle
    - new front WARN locking hubs
    - 4:11 gears
    - safari snorkel
    - both axle's are snorkeled
    - an "ooga" horn
    - custom front bumper with receiver hitch hook up
    - roll bar with 4 spot lights
    - 1 spot light in bed
    - 1 spot light on rear bumper

    This has been a great project truck for me, but I just do not have the time to finish. I just recently purchased the carburetor and the truck runs; however the carburetor's choke does need to be adjusted for easier startup. I also have the receipt for the carburetor if requested. The breaks have recently become slightly spongy. The breaks may just need to be bleed, but I have not had time to check it out. As you can see in the pictures, the passenger side door has diamond plate, however the driver's side door does not, but it still fully functional. This is a real tough truck and I have enjoyed it immensely. I hate to get rid of it, but my loss is your gain! If you are interested and would like to see more pictures please email me at toyrex05@aol.com or call 903-941-1450. I will get back to you as soon as possible.
     

Products Discussed in

To Top