1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

FS: 2nd Gen Short Bed Platform w/ Spare Tire Notch

Discussion in '2nd Gen Tacoma Parts Marketplace (2005-2015)' started by Big_Red_Taco, Nov 16, 2020.

  1. Nov 16, 2020 at 8:36 PM
    #1
    Big_Red_Taco

    Big_Red_Taco [OP] Well-Known Member

    Joined:
    Sep 18, 2017
    Member:
    #230346
    Messages:
    167
    Gender:
    Male
    SoCal
    Vehicle:
    Rad Red '08 DCSB TRD Off Road
    Mostly stock: AP rear plate bumper, CR D-Lights, 4600s
    For Sale in Santa Clarita, CA:

    My custom built lightweight bed shelf "system" for a 2nd Gen short bed Tacoma.

    1/4" plywood on 2x2 frame for lightness and strength. Two 2X6 boards as crossbeams. 8 D-Ring tie down points on shelf (not pictured here, added after pictures were taken).

    The shelves and rear cross beam are notched to allow for a standard Tacoma spare to sit upright against the rear (passenger-side) wall. Can also be used as a rear pass through if a tire isn't present. The shelves are secure with or without a spare tire.

    Shelves are covered with water resistant outdoor carpet, stapled.

    No modifications necessary, just drop in and drive away. Easily added and removed.

    Pickup in Santa Clarita or SFV preferred, willing to drive partway in SoCal. No shipping.

    $125 or best offer.

    TacomaShelfComplete.jpg TacomaShelfCrossbeams.jpg TacomaShelfUnderneath.jpg
     
    Last edited: Nov 16, 2020

Products Discussed in

To Top