FS: BAMF 05 to 2020 bumper reinforcement brackets - black

FS: BAMF 05 to 2020 bumper reinforcement brackets

Note: Some washers and locknuts are missing - see below.

I bought a set of the BAMF 05 to 2020 aftermarket bumper reinforcement brackets to replace the wing reinforcements I already have. After some test fitting I would need to do some work on my Pelfrey bumper that I just had recoated to make these work. I'm not down for that right now so here they are.

These are brand new with no coating scratches or issues.

BAMF webpage: http://bayareametalfab.3dcartstores...ont-bumper-reinforcement-brackets-_p_142.html

Forum thread: https://www.tacomaworld.com/threads...rmarket-bumper-reinforcement-brackets.612276/

I used some of the washers and locknuts on a side project so to get this back to BAMF standards you need the following grade 8 hardware to complete these:
2 - 1/2" locknuts for the long bolts
4 - 1/2" large diameter washers (2 for the 4th short bolt - and - 1 for each of the long bolts, the smaller washers shown are correct for one side)

$OLD Shipped (USPS Flat Rate)

 

Are this still available?

 

Yes

 

Pm sent

 

Pm sent again

 

SOLD