Sold Fs: One peice drive shaft w double cardan joint.400.00 shipped

I had a single peice shaft built by a local driveshaft shop w .080 wall dom and double cardan joint to eliminate any onroad driveline shutter. I've since went away from all onroad driving and put a 2 piece back in permanently. I'm selling this shaft that probably has 1000 miles on it. It had all new Spicer joints put in when they built it. It should will 2005+ second gens tacomas 4 door short bed (and others w same wheel base) If your tired of driveline shutter this is solution. Perfect for lifted trucks. I had 3inch lift and had 3deg shims. I tried everything to elimininate driveline shutter. New center support bearing shims,drop kit ect. Nothing worked except this shaft. Fb: messager nick Kinzie or text/call 513-580-6677.

400$

 

So much want. Too far away

 

So why doesn't this work for off-roading?
Just ground clearance?

 

So much want... currently trying to figure out how to get my hands on this...

 

@DrFunker

 

Yea, less clearance than the 2 piece

 

OP, would you mind getting me a shipping quote to 02132?

 

I can get shipping quotes ..

To answer the question of why no good for off-road it hangs down an extra inch or so. If ur not hanging steep breakovers like this your probably ok.

 

Plan for 60-80 shipping

 

@Boston10Taco

 

Interested. Pm sent.

 

Nevermind. I think I'm gonna go a diff route.

 

Is this sealed or greasable?

 

Owned a driveline company. Shipping was usually around 17-28 on a shaft of this length and weight. Was never anywhere near 60. Even cross country.

 

Roger that.. So plan on 30.00 I'll refund the difference

 

I have 4.88 it will do 80+ mph just fine. 3.5 diameter

 

Price reduction free shipping for you

 

OP, can you get me a full length measurement? Trying to ensure fitment before I pull the trigger here...

 

Sure, I will after work.

 

Awesome, thank you