FS: Ripcord Camper in FL

Selling my 90% complete camper. I never got to sewing the tent and didn’t add the door struts to the side doors but I have the parts plus a parts organizer of extra hardware.

direct bolt in for a 5’ 2nd gen bed. It probably fits a 3rd gen but you’d need to use the clamps to hold it in until you figure out how to extend the mounts to the 3rd Gen bed rails.

no major damage to the camper. Only note is the roof panel was not cut exactly square and I didn’t want to spend another $200 for a panel plus deal with squaring the CNC. It’s not an issue, no leaks into the bed area. I’m in FL and the tent / wedge area has been pretty dry all through monsoon season. The side doors though could use better hinges and waterproofing but it’s never taken on a ton of water.


Asking $2500 will deliver up to 100 miles in FL. But you need 6 people on your end to remove it from my truck to put on yours. you’ll also need to get the slim roof antenna thing before hand


I’ll post more pictures tomorrow

 

Price change 4000 -> 3250.

 

Price changed to $2900

 

@baldridge

 

Someone buy this thing. I need it gone

Will also trade for cash plus 5’ bed shell of any color.

 

$2500 is as low as can go.

 

What’s the height to the top of the camper from the ground?

 

I can get you an exact measurement but with my lift I do not go into parking garages that measure 7' tall openings since the front is right at 7'. the back might be a little higher by an inch or two

 

thanks thats what i needed to know. That def wont work for me then.

 

It depends on your lift but I suspect any other style of camper like this will be pretty close in height.

 

Im on 35s so i know its def not going to work

 

Fine. $2250. Someone come make it yours

 

Wish you where near Oregon