FS URD Spec U Lt headers 2012-2015, CC TX

Selling a set of New URD spec U headers for the 2012-2015 Tacoma. These come with Factory Gaskets, URD hardware, 02 Simulators and 02 harness extenders. Asking $550.00 Shipped in the lower 48. Thanks for looking

 

@05prerun82

 

Will they fit the 05 to 12

 

Yes just need block off plates for the secondary air injection, those cost like 40 bucks

 

I heard they were a pain in the ass to install though what will my 6 inch lift you can pretty much see every single bolt to the headers the problem is is not hard is it to get the header in and out

 

They are a time consuming install, but less so on a 05-11

The steering shaft has to be disconnected to get the driver's side one in place

 

Doooo eeeeet

 

Sunday Bump..

 

Still gots?

 

Why? It’s already going to be blocked on the head if you install in 05-11, no?
Could also just chop off the tubes completely and weld shut.

 

Pm price for pickup? I'm located in Houston

 

Yes the head would be blocked off but you'd need the plates to block off the exhaust tube for the SAI, or like you said cut them off and weld them closed. You'd have an exhaust leak otherwise

 

You sure?? Where’d the leak come from? I only said chop and weld for aesthetics, pretty sure they can just be installed on a 05-11 the way they are

 

where in texas are you, corpus ?

 

No. The air injection tube is just tee'd into the center primary on each header. You'd need to cap the flange or chop the whole thing off and weld up the hole.

 

Ah I see. Yeah that makes sense

 

Pm sent

 

Interested

 

These do have the injection tubes right??

 

Any remote possibility these are CA legal? I doubt it