1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Furnace Flame Sensor Repair and Replace

Discussion in 'Garage / Workshop' started by Eric NJ, Oct 18, 2017.

  1. Oct 18, 2017 at 6:25 AM
    #1
    Eric NJ

    Eric NJ [OP] Well-Known Member

    Joined:
    Dec 30, 2014
    Member:
    #145258
    Messages:
    616
    Gender:
    Male
    New Jersey
    Hey there everyone, this is a huge tip for you guys. The flame sensor in gas furnaces always fail. Usually they just get dirty and you need to clean them. On occasion you need to replace it. In this video I show you how to do both. This is cheap and easy (like a girlfriend I used to have). How do you know if the flame sensor is the issue? The furnace will turn off almost immediately after it turns on.

    Watch Video HERE >> http://tinyurl.com/ybcuntjj

    You can subscribe to the channel here >> https://www.youtube.com/channel/UC-gmqGa0TFBUkzOrfMnBGUQ?sub_confirmation=0

    FURNACE FLAME SENSOR REPAIR AND REPLACE.jpg
     

Products Discussed in

To Top