1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Getting grease gun on CV fitting

Discussion in '1st Gen. Tacomas (1995-2004)' started by dick22, Jul 12, 2014.

  1. Jul 12, 2014 at 4:11 PM
    #1
    dick22

    dick22 [OP] New Member

    Joined:
    May 21, 2012
    Member:
    #79274
    Messages:
    3
    Gender:
    Male
    Idaho
    Vehicle:
    02 TRD
    2002 Tacoma TRD. Opening to CV alimite fittings on the 3-joint rear drive shaft is too tight. I have what I would consider a standard grease gun. No matter how I turn the joint I cannot get square enough contact on the fittings to get grease into either of them.

    Is there a slim grease nozzle that would fit, or how is the CV lubbed?
     
    Last edited: Jul 12, 2014

Products Discussed in

To Top