Greasing the Smittybilt snatch block

I posted this in recovery and got zero hits, hoping for some help here. Picked up the 2744 and a standard zerk coupler is too wide to fit, what is the trick. Needle dispenser?

Thanks.

 

Buy the ARB one.

 

I heard you can grease the snatch block at Big Earls truck stop in Tallahassee... ask for Starla, you’ll know her when you see her.

 

The fitting on the end of grease guns is adjustable to accommodate different sized zerk fittings. Just need to loosen it a bit.

 

ARB one is $90 at least. Smittybilt one is $30...

Damn 3rd gen forums..

 

Get a different fitting on your grease gun. And then get a McKissick and stop half-assing it.

 

Thanks all for the feedback. Appreciate it.

 

3rd gen snatch block?

 

Taller replacement zerk?

 

When the snatch block dries up from my cable running back and forth, I just spit where the cable enters the snatch block. Usually it’s just a quick wench job 30 seconds or less so a little dry friction won’t hurt anything, but some holes require more work and that’s where the spit comes in. Happy wenching and May your snatch block never run dry

 

Good God almighty this was way too easy...And yet I came in with my eyes wide open...Y'all didn't dissapoint!!

 

This has turned out to be more interesting than I intended...





missed opportunity for the recovery forum